Mobeye i110 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Bezpečnostní systémy pro řízení přístupu Mobeye i110. Mobeye i110 User manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 13
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
User manual
Mobeye
®
i110
SW version 5.N
Zobrazit stránku 0
1 2 3 4 5 6 ... 12 13

Shrnutí obsahu

Strany 1 - User manual

User manual Mobeye® i110 SW version 5.N

Strany 2 - Table of content

10 4. ADVANCED OPTIONS 4.1 REQUEST SETTINGS The settings can be sent to the set telephone number as SMS text message. In this way you also check the

Strany 3

11 The Mobeye® now switches on the GSM modules and searches for all present networks. It also checks the network strength of the SIM card provider in

Strany 4

12 5. ISSUE SOLVING Error Possible reason Solution Mobeye® cannot be switched on. You hear an error tone, the red light is turned on shortly. No val

Strany 5

13 Declaration of Conformity Herewith we, Mobeye, declare that the product Mobeye i-110 is in compliance with the essential requirements of t

Strany 6

2 Table of content 1. To get ready in four steps 5 1.1 Step 1: SIM Card 5 1.2 Step 2: Place the batteries 5 1.3 Step 3: Program the phone numb

Strany 7 - Factory setting

3 Attention! Very important This user manual contains important guidelines for the installation and usage of the Mobeye® i110. Please read these tho

Strany 8 - MESSAGE

4 Introduction The Mobeye® is an easy to install alarm system that will notify you in case of a detection using the built-in GSM. To use the Mobeye

Strany 9

5 1. TO GET READY IN FOUR STEPS To get started with the Mobeye® only four steps are needed. 1. Place the SIM card in the Mobeye®. Make sure this SIM

Strany 10

6 2. SWITCHING THE MOTION DETECTOR ON/OFF 2.1 SWITCHING ON To activate the Mobeye® motion detector with your personal user code.  Enter your user

Strany 11

7 3. MOBEYE SETTINGS The Mobeye® settings can be added via the keypad and SMS text messages. First the method of programming is discussed, next the e

Strany 12

8 The Mobeye® first prepares the programming mode. The light flashes red (interval ca. 1 sec). As soon as the light turns green, the Mobeye® is able

Strany 13 - Declaration of Conformity

9 3.6 THE SENSOR SENSITIVITY The detectors’ sensitivity can be changed to a high or low(er) value. 1= High 2 = Low In the high sensitivity mode e

Komentáře k této Příručce

Žádné komentáře